Abstract

The anode and cathode electrodes of a microbial fuel cell (MFC) stack, composed of 28 single MFCs, were used as the negative and positive electrodes, respectively of an internal self-charged supercapacitor. Particularly, carbon veil was used as the negative electrode and activated carbon with a Fe-based catalyst as the positive electrode. The red-ox reactions on the anode and cathode, self-charged these electrodes creating an internal electrochemical double layer capacitor. Galvanostatic discharges were performed at different current and time pulses. Supercapacitive-MFC (SC-MFC) was also tested at four different solution conductivities. SC-MFC had an equivalent series resistance (ESR) decreasing from 6.00 Ω to 3.42 Ω in four solutions with conductivity between 2.5 mScm−1 and 40 mScm−1. The ohmic resistance of the positive electrode corresponded to 75–80% of the overall ESR. The highest performance was achieved with a solution conductivity of 40 mS cm−1 and this was due to the positive electrode potential enhancement for the utilization of Fe-based catalysts. Maximum power was 36.9 mW (36.9 W m−3) that decreased with increasing pulse time. SC-MFC was subjected to 4520 cycles (8 days) with a pulse time of 5 s (ipulse 55 mA) and a self-recharging time of 150 s showing robust reproducibility.

Highlights

  • Microbial fuel cells (MFC) use bacteria to produce electric power by simultaneously degrading organic compounds and thereby treating wastewater [1,2,3]

  • The highest performance was achieved with a solution conductivity of 40 mS cm−1 and this was due to the positive electrode potential enhancement for the utilization of Fe-based catalysts

  • SC-microbial fuel cell (MFC) was subjected to 4520 cycles (8 days) with a pulse time of 5 s and a self-recharging time of 150 s showing robust reproducibility

Read more

Summary

Introduction

Microbial fuel cells (MFC) use bacteria to produce electric power by simultaneously degrading organic compounds and thereby treating wastewater [1,2,3]. PGM-free materials based on the utilization of earth abundant transition metals such as Fe, Co, Mn and Ni have been exploited showing very high electrochemical performance in neutral media, high durability and low affinity with anions and pollutants and low cost [54,55,56,57,58,59,60,61,62,63,64] It was shown using rotating ring disk electrode (RRDE) technique and air-breathing cathode MFC that Fe-based catalysts were the most performing compared to Co, Mn and Ni with Co being the second best [65,66]. Durability tests with 4520 cycles (9 days) of discharge and self-recharge are reported and discussed

Electrode composition
Supercapacitive microbial fuel cell fabrication and operating conditions
Electrochemical measurements
Analysis of full discharges for supercapacitive MFCs
Analysis of SC-MFC for discharges at t pulse equal to 5s
Power generated at different solution conductivities
Analysis of the 4500 cycles
Findings
Outlook and conclusions
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call