Increased Bone Plug Depth From the Joint Increases Tunnel Enlargement in Anterior Cruciate Ligament Reconstruction Using Bone–Patellar Tendon–Bone Autograft With Suspensory Femoral Fixation

Abstract

To determine a safe bone plug depth fixation zone based on early tunnel enlargement rates in anterior cruciate ligament (ACL) reconstruction using bone-patellar tendon-bone (BPTB) autograft with suspensory femoral fixation. Patients who had undergone rectangular tunnel ACL reconstruction using BPTB autograft with suspensory femoral fixation were retrospectively identified. Femoral and tibial tunnel aperture areas were measured on computed tomography 2 weeks and 6 months after surgery to calculate rates of femoral and tibial tunnel enlargement (FTE and TTE), respectively. Femoral bone plug depth (FBPD) and tibial bone plug depth (TBPD) were defined as the distance of the tip of the plug from the respective joint lines. Optimal FBPD and TBPD cutoff values were calculated for the following rates of FTE and TTE, respectively: 0%, 15%, 30%, and 50%. Sixty-four patients (19 females, 45 males; mean age, 29.5 ± 12.3 years) were included in the study. The femoral and tibial tunnel apertures significantly enlarged over time. FBPD (P < .001; r= 0.607) and TBPD (P= .013; r= 0.308) were positively correlated with FTE and TTE, respectively. The optimal FBPD cutoff value was 2.8 mm for FTE rates of 0% and 15%, 3.6 mm for 30%, and 6.0 mm for 50%. The optimal TBPD cutoff value was 1.48 mm for a 0% TTE rate and 5.1 mm for those higher. The cutoff value specificities were lower for the tibial tunnel than the femoral tunnel for each tunnel enlargement rate. Early tunnel enlargement and bone plug depth were significantly correlated in bone the femoral and tibial tunnels. The degree of correlation was higher in the femoral tunnel. To minimize bone tunnel enlargement, the distal end of the femoral bone plug should be placed less than 2.8 mm from the tunnel aperture. Level IV, therapeutic case series.