Abstract
Industrial robots are used in many technical applications from simple pick-and-place tasks to complex machining, welding and assembly applications. The repeatability of the robots is usually high. However, the accuracy is much lower, and it decreases with the robot size selected. Robot calibration represents a possible way to increase accuracy, and two main approaches have been distinguished. Kinematic calibration deals with geometric errors only, and the robot is considered as a rigid body. By contrast, non-kinematic calibration takes into account further sources of errors. This paper deals with kinematic calibration, where an artifact is attached to a robot flange and its position is measured using a laser tracker. The novelty of the method is based on the consecutive rotation of only a single joint, where the artifact trajectory is circular. Real robot geometry is calculated based on identified circles. Numerical simulations seem promising, as well as verification with Stäubli TX2-90, where the accuracy was increased by more than 43%.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
