Abstract
The interpretation of the physico-chemical processes in clouds is facilitated by segregating in situ cloud elements from their carrier gas and small particles (interstitial aerosol). Thus, the present study focuses on the quantitative phase segregation of interstitial air from cloud phase by two complementary samplers with microphysical on-line analysis of the separated phases. An improved counterflow virtual impactor (CVI) was developed for the collection and subsequent evaporation of the condensed phase, releasing dissolved gaseous material and residual particles. This sampler operates in the size range of few micrometers up to 50 μm in cloud element diameter and is matched by an interstitial Round Jet Impactor sampling the gas phase with interstitial particles. Calibrations of both samplers verified the calculated cut sizes D 50 of 4, 5, and 6 μm and quantified the slope of the collection efficiency curves. Until this study no direct CVI measurements of the residual particle sizes far below the diameter of 0.1 μm were available. For the first time a CVI was connected to a Differential Mobility Particle Sizer (DMPS) scanning between 25 nm and 850 nm, thus, including the entire Aitken mode in the residual size analysis. Cloud studies on the Puy de Dôme, France, revealed residual particle sizes including Aitken mode (diameter D<100 nm) and accumulation mode ( D>100 nm). A major feature of the CVI data is expressed by the fact that despite incomplete incorporation of accumulation mode particles in cloud elements there are contributions of particles with diameters smaller than 0.1 μm to the number of residual particles. Cloud entrainment from height levels above the maximum supersaturation as wells as the size-dependent chemical composition of the aerosol population most likely produced the S-shaped size-dependent partitioning of residual particles. Compared to earlier studies the 50% partitioning diameters dropped significantly below 100 nm to roughly 70 nm.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
