Abstract

Abstract Constraints on the amount and pattern of ground deformation induced by dike emplacement are important for assessing potential eruptions. The vast majority of ground deformation inversions made for volcano monitoring during volcanic unrest assume that dikes are emplaced in either an elastic half-space (a homogeneous crust) or a crust made of horizontal layers with different mechanical properties. We extend these models by designing a novel set of two-dimensional finite-element method numerical simulations that consider dike-induced surface deformation related to a mechanically heterogeneous crust with inclined layers, thus modeling a common geometry in stratovolcanoes and crustal segments that have been folded by tectonic forces. Our results confirm that layer inclination can produce localized ground deformation that may be as much as 40× higher in terms of deformation magnitude than would be expected in a non-layered model, depending on the angle of inclination and the stiffness of the rock units that host and are adjacent to the dike. Generated asymmetrical deformation patterns produce deformation peaks located as much as 1.4 km away from those expected in non-layered models. These results highlight the necessity of accurately quantifying both the mechanical properties and attitude of the geology underlying active volcanoes.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call