Abstract

We discovered that Yeast Extract Mannitol (YEM) medium possessed immense potential to generate silver nanoparticles from AgNO3 upon autoclaving, which was evident from (i) alteration in color of the medium; (ii) peak at ∼410 nm in UV-Vis spectrum due to surface plasmon resonance specific to silver nanoparticles; and (iii) TEM investigations. TEM coupled with EDX confirmed that distinct nanoparticles were composed of silver. Yeast extract and mannitol were key components of YEM medium responsible for the formation of nanoparticles. PXRD analysis indicated crystalline geometry and Ag/Ag2O phases in nanoparticles generated with YEM medium, yeast extract and mannitol. Our investigations also revealed that both mannitol and yeast extract possessed potential to convert ∼80% of silver ions in 0.5 mM AgNO3 to nanoparticles, on autoclaving for 30 min at 121°C under a pressure of 1.06 kg/cm2. Addition of filter sterilized AgNO3 under ambient conditions to pre-autoclaved YEM medium and yeast extract brought about color change due to the formation of silver nanoparticles, but required prolonged duration. In general, even after 72 h intensity of color was significantly less than that recorded following autoclaving. Silver nanoparticles formed at room temperature were more heterogeneous compared to that obtained upon autoclaving. In summary, our findings demonstrated that (i) YEM medium and its constituents promote synthesis of silver nanoparticles; and (ii) autoclaving enhances rapid synthesis of silver nanoparticles by YEM medium, yeast extract and mannitol.

Highlights

  • Nanotechnology is one of the most advancing areas of research in modern material science

  • Distinct peaks were seen in UV-Vis spectra at,410 nm (Figure 1b), which are well documented to be due to the surface plasmon resonance in silver nanoparticles [15]

  • Yeast Extract Mannitol (YEM) is a complex medium with mannitol, yeast extract, K2HPO4, MgSO4.7H2O and NaCl as its constituents [14], it was necessary to identify the key component(s) of YEM medium responsible for the formation of silver nanoparticles

Read more

Summary

Introduction

Nanotechnology is one of the most advancing areas of research in modern material science. Nanoparticles exhibit completely new or improved physical (in particular optical, electronic, magnetic) and chemical properties. Nanoparticles of silver show the property of surface plasmon resonance, rendering them to be used in diagnostics and sensing applications [3,4,5,6]. Chemical and physico-chemical approaches such as the use of laser ablation, mechanical milling, inert gas condensation, thermal irradiation, laser irradiation, chemical reduction, photochemical reduction and electrochemical techniques have been demonstrated to generate metal nanoparticles [7,8,9,10,11]. Sodium borohydrate and sodium citrate methods originally discovered by Brust et al [12] and Turkevich et al [13], respectively remain the most popularly used reductants for generation of metal nanoparticles. Owing to the wide applicability and increased commercial demand, the desire to generate nanoparticles in most economically viable and environmentally friendly ways has gained impetus

Methods
Results
Discussion
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call