Abstract
Nonrandomized controlled cohort. To characterize subaxial cervical facet joint kinematics and facet joint capsule (FJC) deformation during in vivo, dynamic flexion-extension. To assess the effect of single-level anterior arthrodesis on adjacent segment FJC deformation. The cervical facet joint has been identified as the most common source of neck pain, and it is thought to play a role in chronic neck pain related to whiplash injury. Our current knowledge of cervical facet joint kinematics is based on cadaveric mechanical testing. Fourteen asymptomatic controls and 9 C5-C6 arthrodesis patients performed full range of motion flexion-extension while biplane radiographs were collected at 30 Hz. A volumetric model-based tracking process determined 3-dimensional vertebral position with submillimeter accuracy. FJC fibers were modeled and grouped into anterior, lateral, posterior-lateral, posterior, and posterior-medial regions. FJC fiber deformations (total, shear, and compression-distraction) relative to the static position were determined for each cervical motion segment (C2-C3 through C6-C7) during flexion-extension. No significant differences in the rate of fiber deformation in flexion were identified among motion segments (P = 0.159); however, significant differences were observed among fiber regions (P < 0.001). Significant differences in the rate of fiber deformation in extension were identified among motion segments (P < 0.001) and among fiber regions (P = 0.001). The rate of FJC deformation in extension adjacent to the arthrodesis was 45% less than that in corresponding motion segments in control subjects (P = 0.001). In control subjects, FJC deformations are significantly different among vertebral levels and capsule regions when vertebrae are in an extended orientation. In a flexed orientation, FJC deformations are different only among capsule regions. Single-level anterior arthrodesis is associated with significantly less FJC deformation adjacent to the arthrodesis when the spine is in an extended orientation. 4.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have