In vivo and in vitro evaluation of marginal fit of class II ceromer inlays

Abstract

The aim of this study was to evaluate the marginal adaptation of class II ceromer (Targis, Vivadent) indirect inlay restorations under both in vivo and in vitro conditions. Twenty Targis inlays were produced for class II inlay cavities (13 mandibular and seven maxillary teeth) in 20 patients. The in vivo adaptation of the inlay to the tooth cavity was evaluated by means of silicone replica technique. For in vitro evaluation, 20 mesio-occluso-distal (MOD) Targis inlays were made in extracted upper molars. Half of the inlays were cemented with Variolink high-viscosity resin cement while the other half was cemented with Variolink Ultra. The replica specimens and in vitro samples were sectioned buccolingually and mesiodistally, and marginal adaptation was evaluated at both proximal and occlusal margins at 200x magnification under a light microscope. The data was analyzed with anova (P < 0.05). The in vivo mean film thickness values for occlusal and proximal locations were recorded as 73 and 132 microm respectively. In vitro mean marginal fit values were observed as 48 and 67 microm for occlusal and proximal margins of inlays luted with Variolink II high viscosity. The marginal fit values recorded under in vivo conditions were higher in magnitude than the measurements obtained under in vitro conditions. The use of a highly filled resin luting agent with an ultrasonic insertion technique did not cause an increase in marginal gap width of the inlay.