Abstract

ABSTRACTObjectives To assess the re-hardening potential of enamel matrix derivatives (EMD) and self-assembling peptides in vitro, hypothesizing that these materials may increase the mineralization of artificial carious lesions and improve hardness profiles.Material and Methods Forty-eight enamel samples were prepared from extracted bovine lower central incisors. After embedding and polishing, nail varnish was applied, leaving a defined test area. One third of this area was covered with a flowable composite (non-demineralized control). The remaining area was demineralized in an acidic buffer solution for 18 d to simulate a carious lesion. Half the demineralized area was then covered with composite (demineralized control), while the last third was left open for three test and one control treatments: (A) Application of enamel-matrix proteins (EMD - lyophilized protein fractions dissolved in acetic acid, Straumann), (B) self-assembling peptides (SAP, Curodont), or (C) amine fluoride solution (Am-F, GABA) for 5 min each. Untreated samples (D) served as control. After treatment, samples were immersed in artificial saliva for four weeks (remineralization phase) and microhardness (Knoop) depth profiles (25-300 µm) were obtained at sections. Two-way ANOVA was calculated to determine differences between the areas (re-hardening or softening).Results Decalcification resulted in significant softening of the subsurface enamel in all groups (A-D). A significant re-hardening up to 125 µm was observed in the EMD and SAP groups.Conclusions This study showed that EMD and SAP were able to improve the hardness profiles when applied to deep demineralized artificial lesions. However, further research is needed to verify and improve this observed effect.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.