In vitro cyanide release from sodium nitroprusside.

Abstract

In vitro release of cyanide from sodium nitroprusside in 5% dextrose in water solution following exposure or non-exposure to fluorescent light (500 ft candles or 791 microwatt per square cm [muWcm-2]), was measured by a cyanide-specific ion electrode at 4, 8, 24, 48, and 72 h. The cyanide concentrations were significantly increased at 24 h in the light-exposed solution. In this group, 100% of the cyanide was released from sodium nitroprusside at 72 h exposure to light. However, cyanide concentrations showed no significant changes for 72 h in the light-protected solutions, which were either exposed to 500 foot candles fluorescent light or stored in a dark room. Less than 2.5% of the cyanide was released from sodium nitroprusside at 72 h in both of the light-protected groups. No significant differences in cyanide concentrations were observed at 8 h among the exposed or non-exposed solutions. After 24 h of exposure, the cyanide concentrations in the exposed group were significantly higher than those of the two light-protected solutions. However, there were no significant differences between the cyanide concentration in the light-protected solutions. These results substantiate the safety of sodium nitroprusside solution for 24 h if the sodium nitroprusside containing solutions are properly protected from light. An additional study performed showed that a significant amount of cyanide released from sodium nitroprusside was adsorbed to the surface of polyvinylchloride.