In vitro assembly of gap junctions

Abstract

Gap junction structures were assembled in vitro from octyl-β- d-glucopyranoside-solubilized components of lens fiber cell membranes. Individual pore structures (connexons), short double-membrane structures, and other amorphous material were evident in the solubilized mixture. Following the removal of the detergent by dialysis, these connexons associated to form single- and double-layered, two-dimensional hexagonal arrays (unit cell size a = b = 8.5 nm). The formation of larger arrays was dependent on the lipid-to-protein ratio and the presence of Mg 2+ ions. Crystallographic analysis of electron micrographs revealed that lens junctional connexons consisted of six subunits surrounding a stain-filled channel. Upon further detergent treatment, in vitro assembled gap junctions were insoluble and formed three-dimensional stacks while other components were solubilized. SDS-PAGE and mass data from scanning transmission electron microscopy strongly suggest that a 38-kDa polypeptide, which is a processed form of the lens specific gap junction protein MP70, is a major component of the arrays. The in vitro assembly of gap junctions opens new avenues for the structural analysis of gap junctions and for the study of the intermolecular interactions of connexons during junctional assembly.