In situ vitrification demonstration for the stabilization of buried wastes at the Oak Ridge National Laboratory

Abstract

A demonstration of In Situ Vitrification (ISV) technology for the stabilization of radioactively contaminated soil sites at the Oak Ridge National Laboratory (ORNL) was successfully completed during July 1987. This demonstration is the first application of the ISV process not performed at the Hanford Site, where the technology was developed and patented for the U.S. Department of Energy by Pacific Northwest Laboratory (PNL). The joint ORNL-PNL pilot-scale demonstration was performed on a 3/8-scale trench (2 m deep × 1 m wide × 10 m long) that was constructed to simulate a typical seepage trench used for liquid low-level radioactive waste disposal at ORNL from 1951 to 1966. In the ISV process, electrodes are inserted around a volume of contaminated soil, power is applied to the electrodes, and the entire mass is melted from the surface of the soil down through the contaminated zone, thus making a glassy-to-microcrystalline waste form that incorporates the contaminants. Gases produced during the melting are collected, treated, monitored, and released through an off-gas process trailer. In the ORNL demonstration, a 25,000-kg mass of melted rock approximately 1.2 m thick × 2.1 m wide × 4.9 m long was formed during 110 h of operation that consumed approximately 29 MWh of power. Data obtained on the operational performance of the test and waste-form durability will be used to assess the feasibility of applying the ISV technology to an actual waste trench.