In Situ Synthesis of Molybdenum Carbide Nanoparticles Incorporated into Laser‐Patterned Nitrogen‐Doped Carbon for Room Temperature VOC Sensing

Abstract

AbstractCarbon laser‐patterning (CLaP) is emerging as a new tool for the precise and selective synthesis of functional carbon‐based materials for on‐chip applications. The aim of this work is to demonstrate the applicability of laser‐patterned nitrogen‐doped carbon (LP‐NC) for resistive gas‐sensing applications. Films of pre‐carbonized organic nanoparticles on polyethylenetherephthalate are carbonized with a CO2‐laser. Upon laser‐irradiation a compositional and morphological gradient in the films is generated with a carbon content of 92% near the top surface. The specific surface areas of the LP‐NC are increased by introducing sodium iodide (NaI) as a porogen. Electronic conductivity and surface area measurements corroborate the deeper penetration of the laser‐energy into the film in the presence of NaI. Furthermore, impregnation of LP‐NC with MoC1−x (<10 nm) nanoparticles is achieved by addition of ammonium heptamolybdate into the precursor film. The resulting doping‐sensitive nano‐grain boundaries between p‐type carbon and metallic MoC1−x lead to an improvement of the volatile organic compounds sensing response of ΔR/R0 = −3.7% or −0.8% for 1250 ppm acetone or 900 ppm toluene at room temperature, respectively, which is competitive with carbon‐based sensor materials. Further advances in sensitivity and in situ functionalization are expected to make CLaP a useful method for printing selective sensor arrays.