In-situ plasma assisted lithium-ion battery cathodes to catalytically pyrolyze lignin for H2-rich syngas production

Abstract

In-situ plasma assisted lithium-ion battery cathodes catalysis was investigated to pyrolyze lignin to H2-rich syngas, oil and char. The effects of temperature, cathode to lignin ratio and plasma current on syngas production were investigated by using the typical ternary cathode NCM111 (LiNi1/3Co1/3Mn1/3O2) as catalyst and adopting dielectric barrier discharge mode. Response surface methodology based on BOX-BEHNKEN design was used to analyze the significance and interactions of process factors on the syngas yield. The conditions of 837℃, 10.4 %, and 185 mA for obtaining high-yield syngas (22.58 %) were more stringent; thereinto, from high to low, the intensity of factors on the yield was temperature, plasma current, and cathode ratio. Furthermore, different cathodes (non-cathode, NCM811 (LiNi4/5Co1/10Mn1/10O2), LCO (LiCoO2), and LMO (LiMn2O4)) were applied to decouple the catalytic effects of three metals in the NCM111. NCM111 enhanced both lignin gasification and carbonization by reducing condensable components, and NCM811 further improved gasification, but LCO and LMO had weaker gasification ability. NCM111 increased H2 volume fraction from 22.35 % to 67.31 %, NCM811 elevated the micro-discharge performance, promoting the hydrogasification reactions between energetic H species and char to produce more CH4, while LCO and LMO tended to produce the CO-rich syngas. Besides, in-situ plasma and its synergy with cathodes inhibited the formation of heavy aromatics and produced some high-value bio-oils rich in light aromatics, in which NCM111 achieved 92.30 % selectivity towards MAHs. High Ni ratio was beneficial for improving the char porosity, and the chars obtained by using NCM811 had a surface area of 409.29 m2/g, and a pore volume of 0.401 cm3/g. Comparably, the degree of catalytic lignin gasification for preparing H2-rich syngas could be ranked as Ni > Co > Mn in the ternary cathode.