Abstract
AbstractThe anionic polymerization of lauryllactam was initiated at 270°C using sodium hydride as an initiator and N,N′‐ethylene‐bisstearamide (EBS) as an activator (NaH:EBS molar ratio of 2). Polymerization occurred in less than 2 min and was successfully performed in an internal mixer and a twin‐screw extruder with corotating intermeshing screws (Werner & Pfleiderer ZSK 25). The content of residual monomer, as determined by thermogravimetric analysis, was lower than 0.5 wt %. Molecular weight, as measured by size exclusion chromatography, was governed by the lauryllactam:NaH molar ratio calculated on a Mn of 25 kg/mol at a constant NaH:EBS molar ratio of 2. Blends were prepared in situ by polymerization of lauryllactam solutions of various polymers. When poly(ethylene‐co‐butylacrylate) (Lotryl®; Atofina) was dissolved in lauryllactam, rubber‐toughened polyamide 12 blends were obtained. Mechanical properties of the injection‐molded polymers were examined by stress–strain as well as notched Charpy impact tests at different temperatures. Blend morphologies were imaged by scanning electron microscopy (SEM). © 2003 Wiley Periodicals, Inc. J Appl Polym Sci 90: 344–351, 2003
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
