Abstract

AbstractStyrene emulsion polymerization was performed in batch reactor using Raman spectroscopy for in situ monitoring of styrene conversion. The variation of the band of trigonal aromatic ring breathing at 1,000 cm−1 was analyzed in detail as a function of monomer conversion (wavenumber, integrated intensity, and half‐width at half‐maximum). The observed variation was described both qualitatively and quantitatively by a model assuming that the overall signal resulted from the addition of two close and distinct Gaussian signals, one originating from the monomer and the other one from the polymer repeat units. A reliable estimation of monomer conversion was obtained using the relative contributions of both components. The results were comparable to those obtained using the ratio of integrated intensities of the band at 1,000 cm−1 (overlapping signals of monomer and polymer) and the band at 1,631 cm−1 (signal specific to monomer). It was shown experimentally that information about monomer conversion could be obtained by applying linear model mixture to a single band of Raman spectrum, which provided an alternative method to the use of a ratio of integrated intensities.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.