In‐situ compressive and tensile performances of high strength engineered cementitious composite at elevated temperatures

Abstract

AbstractThe study provides novel insights on the compressive and tensile strength of high strength engineered cementitious composite (HSECC) at elevated temperatures under in‐situ testing condition. An optimized mix design was employed and cylinder and dogbone specimens were tested to study the compressive and tensile strength of HSECC at elevated temperature. The tested results under in‐situ test condition were compared with the residual state by exposing the specimens to temperature up to 600°C. It was found that specimens under in‐situ condition showed a drastic decrease in compressive strength (26.8%–34.5%) at 200°C and the performance was much inferior to that observed for residual state which showed only 12.2% decrease. This trend was consistent for both tensile and compression test results. After this, the in‐situ specimens underwent slight increase in the compressive strength with only around 25% decrease at 400°C and 14%–16% decrease at 600°C. However, the residual state specimens underwent continuous decrease in strength. Therefore, this study confirmed that for high strength cementitious composites exposed to elevated temperatures, the residual test results should not be considered as the lower limit and in‐situ testing results are essential for accurately predicting the behavior of cementitious composites. Thus, this research underscores the importance of conducting both in‐situ and residual state tests in the design of HSECC structural members.