In-depth Multi-Objective charge pump design space exploration towards the automatic synthesis of power management units

Abstract

Listen

Translate article

The inclusion of automation mechanisms in the intricate design of power management units (PMUs) is long pursued in industry. This paper addresses a mixed-signal design flow whose purpose is to automatically produce, from the system-level to the ready-for-tape-out layout, complex PMUs when given a set of specifications. Particularly, in that flow, at the IP level, the proper analysis of the design tradeoffs is tedious and impractical, as a large amount of conflicting performance figures obtained from transient analysis for typical and multiple process/temperature corners, must be considered simultaneously. Therefore, it is common for the design cycle of a single integrated charge pump required in a state-of-the-art PMU to surpass a full month, depending on the intended technology, devices’ types and operation voltages. Additionally, by the end of this process, circuit designers often end up with a limited vision of the attainable performances. However, due to the recent improvements in computational power of modern workstations, optimization-based techniques with expensive evaluation mechanisms are now perceived as a potential solution to pursue optimal sizing and layout. Therefore, an academic electronic design automation tool is adapted and applied to explore the performance boundaries of a charge pump in a 180-nm technology node and determine the optimal tradeoffs between performance and the, severely constrained, layout area. In the last step, a worst-case corner optimization on a 45- and 99- dimensional design and performance spaces, respectively, derived from 9 time-consuming transient analysis of each candidate solution, produced 35 design solutions that provide a thorough analysis between worst-case efficiency, voltage drop, and rise and fall times, impossible to perform in the manual design. The obtained insights on the design space were used to speed-up the process of devising a solution for tape-out.