IMU-based gait analysis in lower limb prosthesis users: Comparison of step demarcation algorithms

Abstract

BackgroundInertial Measurement Unit (IMU)-based gait analysis algorithms have previously been validated in healthy controls. However, little is known about the efficacy, performance, and applicability of these algorithms in clinical populations with gait deviations such as lower limb prosthesis users (LLPUs). Research questionTo compare the performance of 3 different IMU-based algorithms to demarcate steps from LLPUs. MethodsWe used a single IMU sensor affixed to the midline lumbopelvic region of 17 transtibial (TTA), 16 transfemoral (TFA) LLPUs, and 14 healthy controls (HC). We collected acceleration and angular velocity data during overground walking trials. Step demarcation was evaluated based on fore-aft acceleration, detecting either: (i) maximum acceleration peak, (ii) zero-crossing, or (iii) the peak immediately preceding a zero-crossing. We quantified and compared the variability (standard deviation) in acceleration waveforms from superposed step intervals, and variability in step duration, by each algorithm. ResultsWe found that the zero-crossing algorithm outperformed both peak detection algorithms in 65% of TTAs, 81% of TFAs, and 71% of HCs, as evidenced by lower standard deviations in acceleration, more consistent qualitative demarcation of steps, and more normally distributed step durations. SignificanceThe choice of feature-based algorithm with which to partition IMU waveforms into individual steps can affect the quality and interpretation of estimated gait spatiotemporal metrics in LLPUs. We conclude that the fore-aft acceleration zero-crossing serves as a more reliable feature for demarcating steps in the gait patterns of LLPUs.