Improving the tie force method for progressive collapse design of RC frames

Abstract

PurposeThe purpose of this paper is to recover the deficiency of existing tie force (TF) methods by considering the decrease in section strength due to cracking and by selecting limit state of collapse according to section properties.Design/methodology/approachA substructure is selected by isolating the connected beams from the entire structure. For interior joints, the TFs in the orthogonal beams are obtained by catenary action. For corner joints, the TFs are assessed by beam action. For edge joints, however, the resistance is gained by greater of the resistance under catenary action for periphery beams and beam action for all the connecting beams in both directions. For catenary action, the TF capacities must satisfy Equation (20). On the other hand, for beam action, the TF must satisfy Equation (16), while R is calculated from Equation (17). In the case where the length of the connecting beams is similar, Equation (19) can be used.FindingsClosed form solutions are available for TFs on both beam and catenary stages.Originality/valueThe proposed formulation makes designing more practical and convenient. However, the proposed formulation had good agreement with experimental results.