Improving the standard protocol for above-water reflectance measurements: 1. Estimating effective wind speed from angular variation of sunglint.

Abstract

The standard above-water protocol for measurement of water reflectance uses a measurement of wind speed to estimate the air-water interface reflectance factor and, thus, remove reflected skylight from upwelling radiance. This aerodynamic wind speed measurement may be a poor proxy for the local wave slope distribution in cases such as fetch-limited coastal and inland waters and/or where there are spatial or temporal differences between the wind speed measurement and the location of reflectance measurements. Here, an improved method is proposed, with a focus on sensors mounted on autonomous pan-tilt units and deployed on fixed platforms, replacing the aerodynamic wind speed measurement by optical measurements of angular variation of upwelling radiance. Using radiative transfer simulations, it is shown that the difference between two upwelling (i.e.,water plus air-water interface) reflectances acquired at least 10° apart from each other in the solar principal plane is strongly and monotonically related to effective wind speed. The approach shows good performance in twin experiments using radiative transfer simulations. Limitations of the approach are identified, including difficulties for a very high Sun zenith angle (>60∘), very low wind speed (<2m s -1), and, potentially, cases in which nadir-pointing angles are limited by optical perturbations from the viewing platform.