Abstract
Phase change materials (PCMs), as an effective thermal energy storage technology, provide a viable approach to harness solar heat, a green energy source, and optimize energy consumption in buildings. However, the obstacle preventing widespread practical use of PCM is its poor performance in terms of heat transfer and shape stabilization. This article focuses on the application of the shape stabilization method. To improve the thermal conductivity of organic PCMs (hexadecane), copper microparticles are added to form phase change composites (PCC). This process allows an enhanced PCM (75 wt%) that distributes effective thermal storage capabilities while maintaining low cost. SEM, FTIR, ATG, infrared thermography (IRT), and DSC were used to characterize the composites’ micromorphology, chemical composition, thermal degradation stability, and thermal energy storage capabilities. DSC results showed that a proportion of 75 wt% phase change material with 15 wt% Cu had excellent thermal stability and high energy storage density per unit mass. In light of its high latent heat storage capacity of 201.32 J/g as well as its ability to prevent Hexadecane exudation, PCC ensures higher thermal conductivity and shape stability during phase transition than ordinary PCM. The incorporation of Cu to paraffin causes delay in PCM phase transformation, leading it to respond to rapid charging and discharging rates and, consequentially, to challenges in temperature control, as shown by IRT. The new PCCs had favorable thermal stability below 100 °C, which was advantageous for practical application for thermal energy storage and management, and notably for solar thermal energy storage.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.