Abstract
An Automated Manual Transmission (AMT) is directly derived from a manual one through the integration of actuators; then, development and production costs are generally lower than other automatic transmissions, while the reliability and durability are at highest level. For high class sport cars, vehicle dynamic performances and driving quality can be strongly improved with respect to automatic transmissions [1]. AMTs systems are generally constituted by a dry or wet clutch assembly and a multi-speed gearbox, both equipped with electro-mechanical or electro-hydraulic actuators, which are driven by a control unit, the transmission control unit (TCU). The operating modes of AMTs are usually two: semiautomatic or fully automatic. In both cases, after the gear shift command, the TCU manages the shifting steps according to current engine regime, driving conditions and selected program. In this transmission type the quality of the vehicle propulsion as perceived by the driver is largely dependent on the quality of the control strategies. Furthermore, sensitivity analyses on control schemes for AMTs have shown that uncertainties in clutch torque characteristic can severely affect the performance of the clutch engagement: modeling in detail the torque transmitted by the specific clutch architecture is a crucial issue in order to design robust engagement control strategies [2, 3 and 4]. This paper aims at investigating the engagement performance of an actuated dry clutch by taking into account the inference of the pressure on the facing materials and the sliding speed. In fact, according to literature outcomes [5], the friction coefficient after a first rising behavior with the sliding speed shows an asymptotic value for a typical clutch facing; the same material exhibits a nearly linear dependence of the friction coefficient on the pressure. The simulations consider: reduced-order dynamic system for simulation of passenger car driveline, control algorithm, experimental maps of the n-D clutch transmission characteristic, and gear shift maneuvers in different operating conditions. The outcome of this analysis could provide valuable issues for designers of automated clutches and control engineers to overcome the well known poor engagement performances of open loop motion strategy of the throwout bearing where cost reason and complexity don’t permit the use of displacement sensor.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have