Improving signal integrity in circuit boards by incorporating embedded edge terminations

Abstract

Much attention has been paid toward signal and power integrity in devices, circuit boards and entire systems. Resonances set up between the power and ground planes due to multiple reflections from the edges of the circuit board will affect signal integrity. The impedance seen by a via passing between the power and ground planes can be very high at the resonant frequencies. This gives rise to the effects of crosstalk and simultaneous switching noise (SSN) which would adversely effect the operation of the device. An attempt has been made in this paper to cover all the topics in earlier papers (Shi et al., Proc. Electron. Comp. Technol. Conf., 2001, and Adsure et al., Proc. IPAC'01 Conf., 2001), which describe a method to incorporate (absorbing) at the edges of a circuit board to reduce the wave reflections. The lossy material is usually a of very high resistivity but which shows large magnetic losses at UHF and microwave frequencies. Thus this is suitable to be placed directly between the power and ground planes without introducing any DC leakage currents. Experiments were carried out on a bare copper circuit board with FR-4 dielectric. The absorber used in the experiments is available commercially in flexible, castable and hard dense forms. It is shown that it is possible to reduce the impedances at the resonant frequencies to quite an extent over a broad frequency band by applying the at the edges of the board. Various configurations of applying the are also described.