Abstract

Sensitivity in Nuclear Magnetic Resonance (NMR), especially in solid-state NMR, has always been a challenging and important issue and thus a motivation for new developments. The magnetic field B0, the gyromagnetic ratios of the observed nuclei, as well as the preparation of the samples are important for optimizing the sensitivity. Often only a small amount of sample is available and the nuclei of interest have low gyromagnetic ratios, which makes solid-state NMR extremely time consuming and, in some cases, practically impossible. In addition, strong interactions can cause extensive line-broadening, thus making it difficult to excite or detect high resolution spectra. In this thesis two main aspects concerning sensitivity in solid-state NMR are addressed. The first part reveals the difficulties of the excitation and detection of quadrupolar nuclei, in particular of the highly abundant nucleus nitrogen-14, and presents an indirect detection method combined with a more efficient excitation and reconversion scheme using Delays Alternating with Nutations for Tailored Excitation (DANTE). The second part presents a new experimental set-up for Dynamic Nuclear Polarization (DNP), which has evolved into a very successful method at the Ecole Polytechnique Federale de Lausanne. It is shown in this work that the DNP method combined with solid-state NMR allows one to enhance NMR signal intensities by one or two orders of magnitude, thus opening the doors towards a great variety of new exciting applications. In solids spinning at the magic angle, the indirect detection of single-quantum (SQ) and double-quantum (DQ) 14N spectra (I = 1) via spy nuclei S = 1/2 such as protons can be achieved in the manner of heteronuclear single- or multiple-quantum correlation (HSQC or HMQC) spectroscopy. The coherence transfer is achieved by recoupling the heteronuclear dipolar interactions, i.e., with symmetry-based sequences. The line broadening caused by the homogeneous decay of the transverse terms of the spy nuclei S can be reduced by implementing suitable dipolar decoupling schemes during the evolution period. The lack of efficiency of the excitation and reconversion can be overcome by replacing the conventional rectangular pulses applied to the nitrogen-14 nuclei by a train of short rotor-synchronized pulses in the manner of DANTE. These pulse trains excite a large number of crystallites in the sample uniformly and allow one to efficiently excite magnetization over large bandwidths, limited only by the quality factor of the probe. When combining N interleaved DANTE schemes, obtained by applying N pulses per rotor period, leading to so-called DANTE-N sequences, one obtains methods that greatly improve the uniformity of the excitation and lead to higher signal intensity in less rotor periods than basic DANTE. Applications to nitrogen-14 with fast magic angle spinning (typically νrot ≥ 60 kHz), using either direct or indirect detection, are backed up by simulations that provide insight into the properties of basic and interleaved DANTE sequences. DNP exploits the polarization transfer, driven by microwave irradiation, from unpaired electrons, usually carried by polarization agents such as TEMPO or TOTAPOL, to the target nuclei. This transfer results in enhancements of the signal-to-noise ratios and thus opens many new possibilities for challenging samples. In this thesis the experimental requirements are demonstrated and important parameters like the temperature dependence are investigated. Various sample preparation methods are proposed, e.g., by attaching the radical directly to the molecules under investigation, instead of preparing a solution that should forma glass upon freezing. The combination of indirect detection of 14N with DNP improves the signal-to-noise ratio dramatically and shortens the recovery delay between subsequent experiments. Besides samples of biological interest, it was also shown that the NMR signals of molecules on surfaces of various materials can be greatly enhanced by DNP. A characterization of the distribution of surface binding modes and interactions in a series of functionalized materials could be demonstrated. The bonding topology of functional groups in materials obtained via a sol-gel process and in materials prepared by post-grafting reactions could be identified and compared. Furthermore, the remarkable gain in time afforded by DNP allows the facile acquisition of two-dimensional correlation spectra. The surfaces were characterized by transferring the polarization from protons to other nuclei such as 13C, 29Si and 27Al by means of cross-polarization.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.