Abstract
Adv. Funct. Mater. 2021, 31, 2008767 DOI: 10.1002/adfm.202008767 In the originally published version of the article, the “Device Fabrication and Testing” section in the Supporting Information contains an error. The devices were fabricated by blade-casting (not spin-coating). The processing procedure should read: Then, these blend solutions were blade-coated in ambient atmosphere onto the PEDOT:PSS layer to form active layers. The active layer thickness was controlled by the speed of blade head. The updated J-V curves of the PM6:Y6-2Cl (1:1.2,w/w) devices with diffferent thickness and the corresponding photovotlaic paramters, as shown in Figure S3 and Table S3, respectively, are featured below. The authors apologize for the inconvenience this error may have caused.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
