Abstract
Basic methods for manufacture of large-sized complex-shaped ceramic components by casting from aqueous slips — cryogenic, centrifugal, electrophoretic, etc. — are considered. Of these, the slip casting in porous molds is advantageous in terms of cost and technological simplicity. To achieve further progress, attention should be focused on the development of adequate molding equipment to minimize the rejection rate of finished product.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
