Improving Interfacial and Compressive Properties of Polyimide Fiber by Constructing Inorganic Layers on Fiber Surface.

Abstract

The compressive performance of organic fiber has always been a key problem, limiting its development. In this paper, silicon oxide, alumina, and titanium oxide particles were separately deposited on the surface of high-strength and high-modulus polyimide (PI) fibers to form a structural supporting shell by using a magnetron sputtering method. The theoretical thickness was calculated by thermogravimetric analysis in good agreement with the actual thickness determined from scanning electron microscopy. The mechanics, surface, and interface properties of the measured fibers were analyzed mainly from the aspects of surface energy, interfacial shear strength (IFSS), and compression strength. The results showed that after magnetron sputtering, the inorganic shells were uniformly deposited on the surface of PI fiber, resulting in an increase in the content of inorganic elements as well as the roughness. As a result, the surface energy and IFSS of silica-coated fiber was increased by 174 and 85.6%, respectively, and compression strength was increased by 45.7%. This study provides a new approach for improving the interface property and compression strength of high-strength and high-modulus PI-fiber-reinforced composites.