Improving flexural response of rubberized RC beams with multi-dimensional sustainable approaches

Abstract

This research presents a sustainable solution to waste tire disposal and raw material depletion by incorporating recycled rubber into concrete mixtures. To mitigate the reduction in mechanical properties, a novel slag pretreatment of rubber particles with controlled temperature is proposed. The study also investigates the effects of pouring concrete in layers with rubberized concrete (RuC) in tension side and normal concrete in compression side, as well as evaluating the use of GFRP compared to conventional steel, thereby introducing multiple innovative dimensions to enhance structural performance. The experimental study included a total of 27 specimens, consisting of normal concrete, untreated rubberized concrete, and treated rubberized concrete mixtures with 15 % rubber content. The study investigated both compression and tension mechanical properties of the concrete mixtures and assessed the flexural response of reinforced concrete (RC) beams. Parameters explored included rubber treatment, utilization of steel and GFRP as tensile reinforcement, and layered concrete pouring. Subsequently, a numerical study was conducted to address the impact of reinforcement ratio and layer depth on the behavior of slag-treated rubberized RC beams. The findings reveal a significant recovery of concrete compressive strength by 23 %, along with a 28 % enhancement in toughness and a 17 % increase in splitting tensile strength attributed to the application of slag treatment to rubberized concrete. The effect of rubber treatment was more pronounced in GFRP RC beams, as they showed similar load capacity as normal concrete. Furthermore, utilizing layered concrete beams with a 67 % depth of slag-treated RuC showed a comparable load capacity to normal RC beams, demonstrating only a 1 % reduction for steel-reinforced beams and a 2.4 % improvement for GFRP-reinforced beams. Notably, the numerical model emphasized this outcome and suggested that increasing the layer depth to 72 % of slag-treated depth displayed better performance.