Abstract
This paper is the first part of a two part paper reporting the improvement of efficiency of a one-and-half stage high work axial flow turbine by non-axisymmetric endwall contouring. In this first paper the design of the endwall contours is described and the CFD flow predictions are compared to five-hole-probe measurements. The endwalls have been designed using automatic numerical optimization by means of an Sequential Quadratic Programming (SQP) algorithm, the flow being computed with the 3D RANS solver TRACE. The aim of the design was to reduce the secondary kinetic energy and secondary losses. The experimental results confirm the improvement of turbine efficiency, showing a stage efficiency benefit of 1%±0.4%, revealing that the improvement is underestimated by CFD. The secondary flow and loss have been significantly reduced in the vane, but improvement of the midspan flow is also observed. Mainly this loss reduction in the first row and the more homogeneous flow is responsible for the overall improvement. Numerical investigations indicate that the transition modeling on the airfoil strongly influences the secondary loss predictions. The results confirm that non-axisymmetric endwall profiling is an effective method to improve turbine efficiency, but that further modeling work is needed to achieve a good predictability.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
