Improvement of weldability of TRIP steels by use of in‐situ pre‐ and post‐heat treatments

Abstract

Low alloy TRIP‐aided steels are very interesting for the automotive industry as they combine both a high strength and an excellent formability. Though the actually developed TRIP steels can be considered as low alloyed when compared to the first generations of steels exhibiting TRIP effect, due to their chemical composition, they still exhibit a quite high carbon equivalent. This is particularly detrimental for the weldability of those materials. After solidification, welds are very hard and can show a brittle behaviour. The hardness of the heat affected zone of the welds can even exceed 500HV and cold cracking phenomena is prone to occur.In the automotive industry, spot welding is the main joining process. During spot welding of TRIP steels, the interface between the plates can act like a notch and promote fracture of the weld. This is particularly dangerous when brittle welds are submitted to peel stresses. The aim of the paper is to demonstrate that a careful choice of the process parameters can significantly improve the resistance of the welds. The selection of the welding cycle parameters is far from being an easy task as many different parameters are involved. Therefore, a design of experiment methodology (DOE) was chosen to optimise the welding cycle for a cold‐rolled TRIP steel with a tensile strength above 700 MPa. Mechanical properties of the welds were significantly improved by use of pre‐ and post‐heat treatments. Those improved welding cycles were realised without excessive extension of the total weld cycle on a conventional spot welding machine. This means that the optimised welds can be obtained in the existing production lines without any additional investment or significant decrease in productivity.