Abstract
We have investigated the characteristics of diamond-like carbon (DLC), DLC doped with Cu, and DLC doped with Ti deposited by a sequential pulsed laser ablation of two targets. The composition of these films was determined by Rutherford backscattering spectrometry and X-ray photoelectron spectroscopy (XPS). Raman spectroscopy and transmission electron microscopy studies showed typical features of DLC with a high fraction of sp 3 bonded carbon in the doped films as well as in the undoped films. Wear resistance measurements made on the samples by means of the `crater grinding method' showed that DLC+2.75% Ti has the highest wear resistance, while that of pure DLC has the lowest amongst the samples. Careful analysis of the Raman data indicates a significant shift to shorter wavelength with the addition of metal, which means that the compressive stress in the DLC films has been reduced. We envisaged that the reduction in the compressive stress promotes the wear resistance of the coatings. The XPS studies showed evidence for the formation of Ti–C bonding in the Ti doped sample. Thus metal-doped DLC coatings are expected to improve the tribological properties and enhance the performance of components coated with metal-doped DLC.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
