Abstract
The manufacturing methods of cross-linked polyethylene foams are classified into two categories based on a type of cross-linking. One is chemical cross-linking by using peroxide as a cross-linking agent. The other method is cross-linking by irradiation. As for chemical cross-linking, a fairly thick foam sheet can be produced, and a comparatively high degree of cross-linking can be achieved. This means chemical cross-linking excels in thermo-forming but, due to a rough surface, the product is lacking in adhesive property and printability. We studied how to improve the surface condition of foam sheet without damaging the features proceeding from chemical cross-linking. As a result, it has been revealed that at the pre-stage of foaming, and by irradiating the surface at low voltage, the resultant foamed sheet with smooth surfaces and excelling in mechanical properties can be produced.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.