Abstract
Bulk-heterojunction (BHJ) solar cells utilizing P3HT:PCBM composite using 2.5, 3.5, 5.5 and 7.5 mg of 1, 3, 5-trichlorobenzene (TCB) as co-solvent were fabricated. The co-solvent method can induce a good quality of P3HT:PCBM thin film nanostructure, leading to enhanced absorption. With the optimized TCB quantity, the power conversion efficiency (PCE) achieved with the solar cell was up to 15% better than that attained by a similar device without the presence of TCB. The devices load with and without Niobium doped ZnO Nanoparticles (Nb/ZnO NPs) produced by flame spray pyrolysis (FSP) were also compared.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
