Improvement of the heat transfer quality by air cooling of three‐heated obstacles in a horizontal channel using the lattice Boltzmann method

Abstract

AbstractThis study focuses on the cooling of three heated obstacles with different heights mounted on the bottom of the channel wall using different aspects that influence the enhancement of the heat exchange, as is known in the concept of cooling electronic devices. The lattice Boltzmann method associated with multiple relaxation times (LBM‐MRT) was adopted to simulate the physical configurations of the studied system. In this context, the D2Q9 and D2Q5 models are applied to describe the fluid flow behavior and conjugate heat transfer, respectively. The evaluation of heat exchange between the cold fluid and three‐heated obstacles has been accurately analyzed under the effect of several parameters such as Reynolds number, obstacle spacing, and thermal conductivity ratio. In addition, the setting of two and three fluids flow inlets were also studied. The results are presented in terms of streamlines, isotherms, and local Nusselt curves. The heat transfer increases with increasing solid‐fluid thermal conductivity. It is also more pronounced for large Reynolds numbers. Moreover, the heat transfer significantly enhances for the second and third obstacles when obstacle spacing increases. The improvement of the heat transfer is performed by the implementation of several jet flows in the studied system.