Improvement of anti‐erosion performance of TiN coatings through using a filtration cathode vacuum arc deposition method

Abstract

AbstractSand erosion is a major factor that shortens the service life of aircraft in desert regions. The anti‐erosion performance of titanium alloys may be improved using TiN coatings. However, few studies have employed Ti sputtering on Ti transition layers to improve the erosion resistance of the coatings. Herein, TiN coatings with a sputtering layer between the Ti transition layer and the TiN layer were deposited on a Ti–6Al–4V alloy by filtered cathodic vacuum arc deposition. For comparison, another group of TiN coatings without a Ti sputtering layer but processed using the same deposition parameters were prepared. The effects of the nanoscale sputtering layer on the microstructure, mechanical properties, and anti‐erosion performance of the coatings were investigated using scanning electron microscopy, transmission electron microscopy, X‐ray diffraction, and nanoindentation. The results show that the introduction of a Ti sputtering layer promoted the growth of TiN grains, leading to the formation of finer and denser TiN columnar grains. The preferred orientation of the coatings with the sputtering layer is (111) plane, whereas that of the coatings without the sputtering layer is (200) plane. The TiN coatings containing a sputtering layer exhibit higher hardness, elastic modulus, and H3/E2 ratio, which enhances the anti‐erosion performance of the coatings. The coatings with a sputtering layer exhibited better erosion resistance (erosion rate reduced by 75%) than the coatings without a sputtering layer. The underlying mechanism to understand the effect of the sputtering layer on the erosion resistance was discussed based on variations in the microstructure and mechanical properties of the coatings with and without the Ti sputtering layer. Ti sputtering layer was finally proved to be an effective method to improve the erosion resistance of TiN coatings.