Abstract
Attempts are made in this paper to improve the quality of the stitching between adjacent arc-profiles in the stitching linear-scan method for the roundness measurement of a cylinder in a small dimension. The data in the edge region of an arc-profile, which could be influenced by the pressure angle of the measurement probe of a linear-scan stylus profiler, are eliminated in the stitching process to improve the quality of stitching. The effectiveness of the elimination of the edge region of an arc-profile is evaluated by employing the cross-correlation coefficient of two adjacent arc-profiles as an evaluation index. Furthermore, a modification is made to the experimental setup to reduce the misalignment of a workpiece along its axial direction with respect to the scanning probe. Experiments are carried out by using the modified setup to demonstrate the feasibility of the stitching linear-scan method for the roundness measurement of a small cylinder, which is difficult to measure by the conventional rotary-scan method.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
