Abstract
AbstractIn general, lower viscosity of materials leads to desirable nano‐pattern replication characteristics in injection molding processes. However, such materials do not meet the properties required for manufacturable products owing to their poor mechanical properties. In this study, we blended a small amount of dendrimer with high‐viscosity polyamide 6 to lower viscosity and enhance flowability of the polymer blend while maintaining desirable mechanical properties. It was observed that the flowability of the polyamide 6/dendrimer blend increased significantly with an increase in dendrimer content without affecting the mechanical properties of high‐viscosity polyamide 6. To investigate the nano‐pattern replication characteristics of the blend, injection molding process and the mold of metal stamp were used to manufacture a nano‐pattern specimen. Blending more than 0.6 wt% of dendrimer with high‐viscosity polyamide 6 significantly improved its nano‐pattern replication characteristics and flowability.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.