Improvement in compatibility of hot melt pressure-sensitive adhesive with cinnamon volatile oil and in vitro transdermal property by physical blending

Abstract

Hot melt pressure-sensitive adhesive(HMPSA) has broad application potential in the field of traditional Chinese medicine(TCM) plasters due to its high drug loading, weak skin irritation, satisfactory adhesion, etc. compared with rubber plasters.However, the structure of HMPSA is prone to suffer from the damage caused by volatile oils in TCM plasters. In view of this, a kind of HMPSA with a stable structure was prepared by physical blending of DINCH, polypropylene wax and liquid rubber(LIR) in the present study, which is denoted as DPL. The dosage of cinnamon volatile oil(CVO), the model drug, was selected with viscosity, softening point and cohesion as evaluation indexes. The interaction between DPL and HMPSA was investigated by Fourier transform infrared spectroscopy(FT-IR) and differential scanning calorimetry(DSC). The compatibility of HMPSA with CVO and its transdermal ability were studied by in vitro transdermal test, adhesion, scanning electron microscopy( SEM) and rheological evaluation. The results showed that 5% CVO began to damage the structure of HMPSA. The initial adhesion and holding adhesion of DPL-modified HMPSA(DPL-HMPSA) were not significantly changed compared with those of HMPSA, whereas the 180° peel strength was decreased. FI-IR unraveled that DPL formed the n-π conjugated system with styrene-isoprene-styrene block copolymer(SIS), and there was no significant difference in the glass transition temperature according to DSC results, which indicated the good compatibility of DPL with HMPSA. With 5% CVO loaded, the drug content of DPL-HMPSA was 1. 14 times higher than that of HMPSA, and the decrease rate of drug content in DPL-HMPSA was 16% lower than that in HMPSA after 3 months. SEM demonstrated that CVO did not cause obvious structural damage to DPL-HMPSA. Rheological evaluation revealed that the storage modulus and loss factor of DPL-HMPSA were higher than those of HMPSA, and the cohesion was also stronger. The percutaneous penetration rate of cinnamaldehyde in DPL-HMPSA was 2. 25 times that of HMPSA. In conclusion, DPL-HMPSA had more stable structure, better compatibility with CVO, and higher in vitro transdermal efficiency of cinnamaldehyde than before the modification. This study can provide reference for the mitigation of the matrix structure damage caused by volatile oil components in TCM plasters and the enhancement of the content and in vitro transdermal rate of drug.