Abstract
An Al-Mn-Mg-Sc-Zr alloy was additively manufactured and subsequently deformed to investigate the effect of high defect densities on the precipitation behavior, work hardening capability and ductility. For this, the LPBF-fabricated alloy was deformed by rotary swaging up to a true strain of 2.5 following a laser powder bed fusion (LPBF) process. Compared to the LPBF condition, swaging results in a refinement of the microstructure by one order of magnitude and an increased hardness and ultimate tensile strength (UTS) which is mainly attributed to the finer microstructure of the swaged alloy. By annealing, a higher peak-aging hardness of (209 ± 2) HV0.1 and UTS of (717 ± 2) MPa of the swaged alloy at a lower peak-aging temperature of 300 °C (1 h) was obtained. Significant improvement of uniform elongation by enhanced work hardening capability of the swaged and annealed alloy is obtained for annealing temperatures above 300 °C while strength is only moderately affected. The significant improvement of aging kinetics is discussed alongside a profound microstructural characterization of the heterogeneous grain structure and precipitate distribution.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
