Abstract
Differential mode electromagnetic interference (EMI) at radio frequencies (RF) in compact integrated power electronic converter modules-as due in part to semiconductor switching and structural electromagnetic coupling-can be suppressed by the use of lossy transmission line lowpass filters. A previously reported lowpass filter design for such a system employed a Cu-Al/sub 2/O/sub 3/-Ni-BaTiO/sub 3/-Ni-Al/sub 2/O/sub 3/-Cu lossy uniform width planar transmission line. where the low-permittivity Al/sub 2/O/sub 3/ ceramic wafer merely separates the Cu and Ni conductors. The higher-conductivity Cu conductors served to handle kW-level power frequencies. Above power frequencies, skin-depth restrictions cause current diversion from the Cu line into the inner segment of Ni-BaTiO/sub 3/-Ni that provides subsequent attenuation of milliwatt-level spurious RF interference. Velocity reduction due to the high-permittivity barium titanate (BaTiO/sub 3/) ceramic (/spl epsiv//sub r//spl sim/12,000) enabled compact integrated package size construction (e.g., 10 mm /spl times/1.5 mm /spl times/130 mm). With the aim of increasing the lowpass cutoff response slope, the current paper examines a prototype non-uniform (in width) planar Ni-BaTiO/sub 3/-Ni constituent attenuator segment. For ease of one-dimensional (1-D) ABCD matrix analysis, a four-section Ni-BaTiO/sub 3/-Ni planar attenuator-comprised of four cascaded uniform sections of decreasing step width-was fabricated as a first approximation to an exponential taper. While good agreement was obtained between the predicted and experimental responses of the reverse-connected (narrow-to-wide) attenuator up to about 30 MHz, the discrepancy between the experimental and theoretical forward-connected (wide-to-narrow) frequency responses is attributed here to three-dimensional current constrictions at step interfaces. It is postulated that this can be overcome by the alternate use of a linearly- or an exponentially-tapered line.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IEEE Transactions on Components and Packaging Technologies
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
