Improved stability in P3HT:PCBM photovoltaics by incorporation of well‐designed polythiophene/graphene compositions

Abstract

AbstractMorphological and photovoltaic stabilities of poly(3‐hexylthiophene) (P3HT):phenyl‐C61‐butyric acid methyl ester (PC71BM) solar cells were investigated in pristine and modified states. To this end, four types of patterned/assembled nanostructures, namely reduced graphene oxide (rGO)‐g‐poly(3‐dodecylthiophene)/P3HT patched‐like pattern, rGO–polythiophene/P3HT/PC71BM nanofiber, rGO‐g‐P3HT/P3HT cake‐like pattern and supra(polyaniline (PANI)‐g‐rGO/P3HT), were designed on the basis of rGO and various conjugated polymers. Intermediately covered rGO nanosheets by P3HT crystals (supra(PANI‐g‐rGO/P3HT)) performed better than sparsely (patched‐like pattern) and fully (cake‐like pattern) covered ones in P3HT:PC71BM solar cell systems. Supra(PANI‐g‐rGO/P3HT) nanohybrids largely phase‐separated in active layers (root mean square = 0.88 nm) and also led to the highest performance (power conversion efficiency of 5.74%). The photovoltaic characteristics demonstrated decreasing trends during air aging for all devices, but with distinct slopes. The steepest decreasing plots were obtained for the unmodified P3HT:PC71BM devices (from 1.77% to 0.28%). The two supramolecules with the most ordered structures, that is, cake‐like pattern (10.12 mA cm−2, 51%, 0.58 V, 2.2 × 10−6 cm2 V−1 s−1, 4.3 × 10−5 cm2 V−1 s−1, 0.69 nm and 2.99%) and supra(PANI‐g‐rGO/P3HT) (12.51 mA cm−2, 57%, 0.63 V, 1.2 × 10−5 cm2 V−1 s−1, 3.4 × 10−4 cm2 V−1 s−1, 0.82 nm and 4.49%), strongly retained morphological and photovoltaic stabilities in P3HT:PC71BM devices after 1 month of air aging. According to the morphological, optical, photovoltaic and electrochemical results, the supra(PANI‐g‐rGO/P3HT) nanohybrid was the best candidate for stabilizing P3HT:PC71BM solar cells. © 2020 Society of Chemical Industry