Abstract
Abstract Cyclic waterflooding is an IOR-method that improves oil production in heterogeneous reservoirs with high-permeability contrast. The concept of the method is based on pulsed injection and alternating of waterflood patterns. The main effect induced by the cycling of wells is oil production increase accompanied by water production decrease. The production increase is achieved by improved sweep efficiency in low permeable zones of a reservoir non swept by traditional waterflooding process. The cyclic water injection process was successfully applied in a number of sandstone and carbonate oil fields in Russia, USA and China. The important advantages of the method are virtually zero additional cost and simple implementation procedure. The uncertainty with the method is related to understanding the IOR mechanism, ability to accurately model the process and design a field application. The paper presents the results of the study of cyclic water injection and oil production at a North Sea heterogeneous sandstone reservoir. The study consists of the field history analysis, pre-screening cyclic efficiency estimation and numerical reservoir simulation to design the field application of the IOR-method. The field history analysis shows the presence of cycles in injection and production and their influence on water-cut change. Pre-screening analytical tool was used to perform a wide-range sensitivity analysis with respect to rock-fluid parameters, heterogeneity, cycle length and pressure conditions in order to understand the mechanism and to estimate the IOR potential. Finally the sector model reservoir simulation was used to optimize the cyclic process by alternating the waterflood patterns and to design the field application. The simulations show decrease of water production and improvement of oil production by up to 3% with short time and by 5% with long time cycles.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have