Abstract

We introduce quantitative polymerase chain reaction (qPCR) primers and multiplex end-point PCR primers modified by the addition of a single ortho-Twisted Intercalating Nucleic Acid (o-TINA) molecule at the 5′-end. In qPCR, the 5′-o-TINA modified primers allow for a qPCR efficiency of 100% at significantly stressed reaction conditions, increasing the robustness of qPCR assays compared to unmodified primers. In samples spiked with genomic DNA, 5′-o-TINA modified primers improve the robustness by increased sensitivity and specificity compared to unmodified DNA primers. In unspiked samples, replacement of unmodified DNA primers with 5′-o-TINA modified primers permits an increased qPCR stringency. Compared to unmodified DNA primers, this allows for a qPCR efficiency of 100% at lowered primer concentrations and at increased annealing temperatures with unaltered cross-reactivity for primers with single nucleobase mismatches. In a previously published octaplex end-point PCR targeting diarrheagenic Escherichia coli, application of 5′-o-TINA modified primers allows for a further reduction (>45% or approximately one hour) in overall PCR program length, while sustaining the amplification and analytical sensitivity for all targets in crude bacterial lysates. For all crude bacterial lysates, 5′-o-TINA modified primers permit a substantial increase in PCR stringency in terms of lower primer concentrations and higher annealing temperatures for all eight targets. Additionally, crude bacterial lysates spiked with human genomic DNA show lesser formation of non-target amplicons implying increased robustness. Thus, 5′-o-TINA modified primers are advantageous in PCR assays, where one or more primer pairs are required to perform at stressed reaction conditions.

Highlights

  • Optimization of a conventional quantitative polymerase chain reaction assay requires consideration of a number of different parameters such as primer design, primer concentration, buffer composition, choice of polymerase and assay temperature profile

  • A trade-off must be made between sensitivity and specificity - high primer concentrations and low annealing temperature will maximize analytical sensitivity and quantitative polymerase chain reaction (qPCR) efficiency at the cost of cross-reactivity and specificity and vice versa

  • We demonstrate the effect of an ortho-Twisted Intercalating Nucleic Acid (o-Twisted Intercalating Nucleic Acid (TINA)) modification on the 59- position of the qPCR primers

Read more

Summary

Introduction

Optimization of a conventional quantitative polymerase chain reaction (qPCR) assay requires consideration of a number of different parameters such as primer design, primer concentration, buffer composition, choice of polymerase and assay temperature profile. Another fundamental challenge in the development of qPCR assays for clinical diagnostics, e.g. for infectious diseases, is the frequent need for highly multiplexed assays to cover all relevant targets [1]. The optimal qPCR conditions were identified as the combination of the maximum annealing temperature (Ta) and the minimum primer concentration (Cprimers) allowing for 100% qPCR efficiency Based upon these optimal reaction conditions for unmodified DNA primers, the qPCR assay was further incrementally stressed by increasing the Ta and decreasing the Cprimers. To ensure the applicability of our findings to PCR assays in general, we have tested the impact of 59-o-TINA modified primers on a previously published octaplex end-point PCR assay, which is routinely used in clinical microbiology for identification of human diarrheagenic Escherichia coli (E. coli) and Shigella species [18]

Materials and Methods
Results
Findings
Discussion
Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.