Abstract
AbstractGas‐assisted sheet extrusion is a promising and environment‐friendly method used in polymer processing. Insufficient gas intake due to the adherence of the polymer melt to the inlet gap is a disadvantage of the method. Therefore, in this study an improved die assembly with parallel gas intake was designed. As the melt is prone to falling at the die exit during the horizontal extrusion process, different thickness settings are used for the up and down gas layers (0.25 and 0.75 mm, respectively) to avoid this. For the improved die assembly, the gas inlet pressure may be varied systematically to study the mechanism of stable sheet extrusion. When the gas inlet pressure is 0.1 MPa, the melt can be extruded smoothly, and the extruded sheet surface is transparent and flat. However, when the optimum pressure is exceeded, the extruded sheet becomes twisted or even broken.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
