Improved Compartment Balancing Using a Robot-Assisted Total Knee Arthroplasty.

Abstract

BackgroundRobot-assisted surgery was developed to improve accuracy and outcomes in total knee arthroplasty (TKA). One important determinant of TKA success is a well-balanced knee throughout the range of motion. The purpose of this study is to determine if robot-assisted TKA (RA-TKA) results in improved intracompartmental ligament balance compared with conventional jig-based instrumentation (CM-TKA).MethodsThis retrospective cohort study included 2 cohorts—a CM-TKA (n = 49) vs RA-TKA (n = 37) cohort. Demographic and intraoperative data, including intraoperative compartment loads, were measured after final implant implantation in extension (10°), mid-flexion (45°), and full flexion (90°), using an intraoperative compartment pressure sensor. An a priori power analysis revealed our study exhibited >80% power in detecting a 5-pound (lb) difference in compartment loads in the 2 cohorts.ResultsThere was no difference between medial and lateral compartment loads in extension, mid-flexion, and full flexion for the conventional (15.1 lbs, 15.9 lbs, and 13.4 lbs, respectively) vs RA-TKA (14.2 lbs, 15.1 lbs, and 10.3 lbs, respectively). The percentage of patients with high load compartment pressure in flexion (>40 lbs) by the conclusion of the surgery was significantly greater for the conventional (18%) vs the robotic TKA cohort (3%, P = .025). The percentage of patients with unbalanced knees (>20 lbs differential between medial and lateral compartments) in flexion was significantly greater in the conventional (24%) vs robotic TKA cohort (5%, P = .018).ConclusionsIn this series, RA-TKA resulted in improved intraoperative compartment balancing in flexion with no observed difference in mid-flexion and extension compared with CM-TKA.