Abstract
In this paper a new circuit design for automatic electrostatic vibroscopes is presented. Previously, the component which stabilized the self-oscillatory motion of the filament in the feedback loop of electrostatic vibroscopes was a negative temperature coefficient thermistor. In the present system this device is replaced with a programmable analog compander. This modification represents an improvement because response time is faster, the steady-state conditions are more stable, and the overall performance of the vibroscope is less susceptible to errors caused by changes in environmental conditions.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.