Abstract
3D PRINTING OF MAGNETIC SEPARATOR: AN AFFORDABLE APPROACH TO SAMPLE PREPARATION IN THE COVID-19 DIAGNOSIS. This report describes the fabrication of a low-cost magnetic separator holder combining 3D printing and compact neodymium blocks for allowing magnetic extraction and purification of RNA from samples collected by nasopharyngeal swab from patients infected by SARS-CoV-2. The device was designed to contain 24 entrances for plastic microtubes in an arrangement like a commercial device. The proof of concept of the proposed device was successfully demonstrated through the sample extraction and purification of swab samples collected from eight patients suspected of SARS-CoV-2 infection. The sample preparation protocol was performed using a commercial kit containing magnetic beads and different solutions. The performance of the printed device was compared to a commercial magnetic separator, usually employed in the golden standard techniques. The fabrication of the 3D printed magnetic separator was completed under optimized printing conditions within 6 h at cost of 4 USD per unit. The RNA extracted from samples using both devices was analyzed by reverse transcriptase quantitative polymerase chain reaction (RT-qPCR) and the achieved results have indicated no statistical different at confidence level of 95%. Based on the achievements, the use of 3D printing and neodymium blocks have demonstrated an alternative route to be used in routing analysis associated to COVID-19 diagnosis.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have