Abstract

During work on the uptake of phosphate ions by clays and other minerals in sea water, using such low concentrations as between 30 and 2,000 mg P/m3, the phosphate adsorption on a variety of plastics and glass had to be examined. It was found that at the pH‐range between 7.5 and 8 a considerable uptake of phosphate ions takes place.Phosphate adsorption on polyethylene and polyvinyl chloride was found to be about 3 times as high as the adsorption on glass under comparable experimental conditions. Even Teflon resin adsorbed phosphate ions, but apparently at a slower rate than glass and the plastics examined.The impregnation of glass with Desicote was inefficient, but treatment of our glass equipment with 0.5 to 1% hydrofluoric acid either in 2 n hydrochloric acid or in distilled water finally prevented the uptake of any considerable amounts of phosphate. Prevention of adsorption of other anions by this treatment is likely.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.