Abstract
Residential solar Photovoltaic (PV) installations are increasing at a very high pace in the United States. In 2017 there are approximately one million residential solar PV installations in the US. A significant share of these installations are downstream of distribution transformers and thus connected to the secondary. To precisely analyze voltage variations induced by PV systems into distribution systems, accurate models of load and PV systems connected to the secondary side of distribution transformers are required. In the work here we consider two secondary circuit modeling approaches, simple secondary and detailed secondary models. In simple secondary models all loads and all PV generators below a distribution transformer are modeled as an aggregate load and an aggregate PV generator. In the detailed secondary models all loads and PV systems below the distribution transformers are modeled individually and secondary conductors and service drops are also modeled. Using a cloud motion simulator it is observed that employing the simple secondary models can lead to inaccurate and conservative results. Moreover, the locations with the greatest voltage changes are different in the two modeling approaches. This paper highlights the importance of utilizing detailed secondary models over simple secondary models in analyzing PV generation.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.